Prerequisites

• A Webdock Ubuntu Noble server
• Root or sudo access to your server

Node and NPM Installation

N8N requires Node to be installed.

Let's start by system update and upgrade.

$ sudo apt update
$ sudo apt upgrade

Install NVM.

$ curl -o- https://raw.githubusercontent.com/nvm-sh/nvm/v0.40.3/install.sh | bash

Source config after NVM installation.

$ \. "$HOME/.nvm/nvm.sh"

Install Node

$ nvm install 22

The above command installs Node version 22, along with NPM.

Verify the Node.js version.

$ node -v # Should print "v22.16.0".
$ nvm current # Should print "v22.16.0".

Verify npm version:

$ npm -v # Should print "10.9.2".

Now that we have installed Node and NPM, let's install n8n

N8N Installation

Run the below command to install n8n

$ npm install n8n -g

Now, to run n8n, we use the command:

$ n8n start

Now, you should visit your server’s ip with the port 5678 and view your n8n instance.

http://server-ip:5678

The app will not start automatically; for it to do so, you will need to create a service for it.

Switch to root first.

$ sudo su

Create a service file.

# touch /etc/systemd/system/n8n.service

Open the file with your favorite file editor. I choose nano.

# nano /etc/systemd/system/n8n.service

Add the below lines to the service file.

Note: You must change the ExecStart command by replacing the /home/admin with your shell user home directory. And the "User" with your shell username.

[Unit]

Description=n8n
Documentation=https://n8n.io
After=network.target

[Service]

Environment=NODE_PORT=5678
Environment=N8N_SECURE_COOKIE=false
Type=simple
User=admin
ExecStart=/home/admin/.nvm/versions/node/v22.16.0/bin/n8n
Restart=on-failure

[Install]

WantedBy=multi-user.target

Then run the command daemon-reload, to load the new service to systemd.

# systemcl daemon-reload

And finally, to get it to auto-start, use the commands.

# systemctl enable n8n.service
# systemctl start n8n.service

To make sure it’s running use the command.

# systemctl status n8n.service

It should say that’s enabled and active.

As a sidenote

If you get the following error, make sure ssl is installed on your server, or use the below commands as a workaround.

Note: Make sure to run the below commands as the same shell user you run the n8n (using n8n start).

$ echo 'export N8N_SECURE_COOKIE="false"' >> ~/.bashrc
$ source ~/.bashrc

This is a temporary solution, as for best practices, it is more secure to run SSL on your server.

Conclusion

This guide outlined steps to setup n8N on your Webdock server. We hope this tool fits your automation needs!

Please reach out to Webdock Support if you need any further assistance.

This article was written by Webdock Support Specialist Jose Porras. Jose is passionate about Cloud Hosting and helping Webdock Customers succeed wherever he can.